Insert the switch into the elbow and Tee fitting with one tube-covered wire extending from each end. The plastic coating on the wire is to protect you from being electrocuted! You don’t want to damage that wire! The tubing helps prevent the plastic coating on the wire from being damaged on the abrasive interior of the pipes. )Ĭut two pieces of the smaller vinyl tubing about 3″ long and slide one over each of the rotary switch wires, stopping about an inch from the switch. If the elbow, once tightened, is not at the right angle, wrap with 2 – 3 turns of Teflon tape and retighten. Not all the threading starts in the same spot. Thread the male end of a 90° Street Elbow into one end of the 1″ Tee. The Lamp Cord we chose is an 8′ Silver cord.ĭisclaimer – A word of caution here, work with a licensed electrician or a certified professional to help with wiring your lamp. We are not responsible for any action taken as a result of the information or advice on. After roughing this up, we realized there was a possibility of the socket causing a potential short and we chose the safer light socket.Ĭreate your own amazing industrial pipe lamp!Ĭlick here to grab your own copy of this Illustrated Step-by-Step Guide! Industrial Pipe Lamp – E-Book For this Industrial Pipe Lamp project, you will need: Note in this picture, this type of light socket was changed to the kind in the picture and the materials list below. This may look like a disparate group of items, but when assembled together in a particular way, the end result makes a real conversation piece! ![]() Then, using the directions, I put together a second one, which will be on the wall in the game room. Jon-Michael put this first one together as I took photos of the process. While you and I may not be savvy with all the plumbing paraphernalia, here, Jon-Michael, who works at the local Ace Hardware store, has come up with an easy DIY project! How cool is this? Can you imagine the impression made when you turn the red handle on the gate valve and the light comes on? Have you seen the ‘industrial pipe lamps’, which seem to be one of the new trends? They have a Steampunk look, don’t they? Yes, they are so unique! They also have a hefty price on them but how difficult would it be to make an industrial pipe lamp at home? And at what cost?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |